Welcome Guest! To enable all features please Login or Register.
Go to last post Go to first unread
#1 Posted : Tuesday, November 20, 2018 9:29:10 AM(UTC)

Rank: Newbie

Groups: Registered
Joined: 11/20/2018(UTC)
Posts: 1

I recently purchased a 2016 Hyper X6. It has the wishbone/jacob's ladder setup in the rear. There is a lot going on back there. I've been trying to review installation manuals and setup docs. on the website, but I'm having a hard time understanding/knowing exactly what I'm looking at. I don't know if the previous owner has items mounted correctly. Where the jacob's ladder mounts to the frame on the bottom frame rail, the pin/bolt used is a size smaller than the hole. Is this correct? It is awfully sloppy.

Are there more detailed instructions or better pics showing what the standard setup/build should look like?


Mike Dicely  
#2 Posted : Tuesday, November 20, 2018 10:22:04 AM(UTC)
Mike Dicely

Rank: Administration

Groups: Administrator, Pay Per View, Administrators, Registered
Joined: 2/1/2011(UTC)
Posts: 761
United States
Location: Etters, PA

Thanks: 1 times
Was thanked: 133 time(s) in 132 post(s)
Hello Andy, Congrats on your purchase and welcome to the Hyper Family!

You can see the Jacob's Ladder in some of the Chassis Tour shots pretty good. Here is a link to that page

That bottom tab can wear, also we have tightened up our tolerances on that tab over the last couple years, so the new tabs have a smaller hole in them. I don't have any more specific instructions.

Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.