Welcome Guest! To enable all features please Login or Register.
Go to last post Go to first unread
#1 Posted : Friday, October 22, 2021 2:41:25 PM(UTC)

Rank: Newbie

Groups: Registered
Joined: 4/20/2021(UTC)
Posts: 3

my front panard is mounted to the axle fixed on the left , chassis slider on the right . most in these cars run the slider about an inch above the axle at ride height.. what effects would it have if I was to switch and run it below so its like the rear bar is?
Mike Dicely  
#2 Posted : Monday, October 25, 2021 8:29:56 AM(UTC)
Mike Dicely

Rank: Administration

Groups: Administrator, Pay Per View, Administrators, Registered
Joined: 2/1/2011(UTC)
Posts: 760
United States
Location: Etters, PA

Thanks: 1 times
Was thanked: 133 time(s) in 132 post(s)
Lowering the front roll center, which is what you would do if you moved it below the axle, will transfer less weight from the LF to the RF and more from the LR to the RR. This, in general, depending on corner weight ands spring rates, will loosen the car. Roll center heights also change "how" the weight transfers. a lower roll center will transfer the weight more elastically (through the springs) and less geometrically (through the lateral locating device, in this case the panhard bar. elastic weight transfer happens slower than geometric.
Users browsing this topic
Guest (2)
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.